Result:
git-log-oneline i915_display_info0 igt_runner0 run0 runtimes0 results0.json guc_logs0.tar i915_display_info_post_exec0 boot0 dmesg0
| Detail | Value |
|---|---|
| Duration | 0.00 seconds |
| Igt-Version |
IGT-Version: 2.2-gaca02d1cc (x86_64) (Linux: 6.18.0-next-20251211-next-20251211-g5ce74bc1b7cb+ x86_64) |
| Out |
Using IGT_SRANDOM=1765419485 for randomisation Opened device: /dev/dri/card0 No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. Subtest basic-busy-flip-before-cursor-atomic: SKIP (0.000s) No valid crtc/connector combinations found. |
| Err |
Subtest basic-busy-flip-before-cursor-atomic: SKIP (0.000s) |
| Dmesg |
<6> [71.309133] [IGT] kms_cursor_legacy: executing
<7> [71.313679] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [71.314315] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [71.314610] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [71.317902] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:106:DP-1]
<7> [71.317909] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:106:DP-1]
<7> [71.318153] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on
<7> [71.322596] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:106:DP-1] disconnected
<7> [71.322917] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:118:DP-2]
<7> [71.322923] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:118:DP-2]
<7> [71.323691] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [71.324215] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [71.324785] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2
<7> [71.325727] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00
<7> [71.326472] i915 0000:00:02.0: [drm:drm_dp_dump_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000
<7> [71.327356] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:118:DP-2] disconnected
<7> [71.327696] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:124:HDMI-A-1]
<7> [71.327701] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:124:HDMI-A-1]
<7> [71.328143] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.328343] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry
<7> [71.328725] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.328935] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.328939] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [71.329144] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1
<7> [71.333481] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.333485] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0
<7> [71.333670] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:124:HDMI-A-1] disconnected
<7> [71.333902] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:106:DP-1]
<7> [71.333906] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:106:DP-1]
<7> [71.338231] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:106:DP-1] disconnected
<7> [71.338246] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:118:DP-2]
<7> [71.338250] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:118:DP-2]
<7> [71.339197] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00
<7> [71.339988] i915 0000:00:02.0: [drm:drm_dp_dump_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000
<7> [71.340873] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:118:DP-2] disconnected
<7> [71.340901] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:124:HDMI-A-1]
<7> [71.340905] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:124:HDMI-A-1]
<7> [71.341400] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.341593] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry
<7> [71.341977] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.342230] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.342235] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [71.342434] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1
<7> [71.346702] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.346706] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0
<7> [71.346890] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:124:HDMI-A-1] disconnected
<6> [71.347715] [IGT] kms_cursor_legacy: exiting, ret=77
<7> [71.348110] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [71.348415] i915 0000:00:02.0: [drm:drm_client_dev_restore] fbdev: ret=0
|