Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Duration | 0.00 seconds |
| Igt-Version |
IGT-Version: 1.28-g21e9f1e49 (x86_64) (Linux: 6.8.0-rc5-linus-v6.8-rc5-gb401b621758e+ x86_64) |
| Out |
Using IGT_SRANDOM=1708290493 for randomisation Opened device: /dev/dri/card0 Starting subtest: basic-y-tiled-legacy Subtest basic-y-tiled-legacy: SUCCESS (0.000s) |
| Err |
Starting subtest: basic-y-tiled-legacy Subtest basic-y-tiled-legacy: SUCCESS (0.000s) |
| Dmesg |
<6> [89.104469] Console: switching to colour dummy device 80x25
<6> [89.104509] [IGT] kms_addfb_basic: executing
<7> [89.106586] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [89.107287] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [89.124038] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [89.124983] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000)
<7> [89.125242] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:283]
<7> [89.125593] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:283]
<7> [89.125780] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:283]
<6> [89.126269] [IGT] kms_addfb_basic: starting subtest basic-y-tiled-legacy
<7> [89.126327] i915 0000:00:02.0: [drm:intel_fb_bo_framebuffer_init [i915]] No Y tiling for legacy addfb
<7> [89.126565] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<6> [89.126620] [IGT] kms_addfb_basic: finished subtest basic-y-tiled-legacy, SUCCESS
<7> [89.134551] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1]
<7> [89.134560] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:246:DP-1]
<7> [89.134806] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1] disconnected
<7> [89.135349] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1]
<7> [89.135354] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:258:HDMI-A-1]
<7> [89.146025] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out after NAK
<7> [89.146346] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] NAK for addr: 0050 w(1)
<7> [89.157066] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out after NAK
<7> [89.157565] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] NAK for addr: 0050 w(1)
<7> [89.209079] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out, falling back to bit banging on pin 10
<7> [89.226169] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [89.226176] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [89.226314] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus tc2. force bit now 1
<7> [89.243190] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [89.243195] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus tc2. force bit now 0
<7> [89.243331] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1] disconnected
<7> [89.243766] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2]
<7> [89.243769] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:264:DP-2]
<7> [89.243951] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2] disconnected
<7> [89.244326] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3]
<7> [89.244329] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:273:DP-3]
<7> [89.244497] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3] disconnected
<7> [89.244974] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:236:eDP-1]
<7> [89.244977] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:236:eDP-1]
<7> [89.245689] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [ENCODER:235:DDI B/PHY B] MST support: port: no, sink: no, modparam: yes
<7> [89.245795] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] source rates: 162000, 216000, 270000, 324000, 432000, 540000, 648000, 810000
<7> [89.245909] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] sink rates: 162000, 270000
<7> [89.246007] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] common rates: 162000, 270000
<7> [89.246121] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] Supported Monitor Refresh rate range is 0 Hz - 0 Hz
<7> [89.246126] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] Assigning EDID-1.4 digital sink color depth as 8 bpc.
<7> [89.246129] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] ELD monitor
<7> [89.246131] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] ELD size 20, SAD count 0
<7> [89.246144] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:236:eDP-1] VRR capable: no
<7> [89.246243] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:236:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [89.247064] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] PCON ENCODER DSC DPCD: 00 00 00 00 00 00 00 00 00 00 00 00 00
<7> [89.247163] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:236:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<7> [89.247882] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:236:eDP-1] probed modes :
<7> [89.247885] [drm:drm_mode_debug_printmodeline] Modeline "1920x1080": 60 138780 1920 1968 2000 2080 1080 1083 1088 1112 0x48 0xa
<7> [89.247890] [drm:drm_mode_debug_printmodeline] Modeline "1920x1080": 48 111040 1920 1968 2000 2080 1080 1083 1088 1112 0x40 0xa
<7> [89.247906] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1]
<7> [89.247910] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:246:DP-1]
<7> [89.248095] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1] disconnected
<7> [89.248111] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1]
<7> [89.248115] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:258:HDMI-A-1]
<7> [89.299069] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out, falling back to bit banging on pin 10
<7> [89.316145] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [89.316150] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [89.316263] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus tc2. force bit now 1
<7> [89.332189] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [89.332193] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus tc2. force bit now 0
<7> [89.332313] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1] disconnected
<7> [89.332337] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2]
<7> [89.332342] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:264:DP-2]
<7> [89.332534] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2] disconnected
<7> [89.332546] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3]
<7> [89.332549] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:273:DP-3]
<7> [89.332714] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3] disconnected
<6> [89.333020] [IGT] kms_addfb_basic: exiting, ret=0
<7> [89.333220] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<6> [89.384818] Console: switching to colour frame buffer device 240x67
|