Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Duration | 0.00 seconds |
| Igt-Version |
IGT-Version: 1.28-g619c3f3ff (x86_64) (Linux: 6.7.0-rc8-linus-v6.7-rc8-g610a9b8f49fb+ x86_64) |
| Out |
Using IGT_SRANDOM=1704057454 for randomisation Opened device: /dev/dri/card0 Starting subtest: bo-too-small-due-to-tiling Subtest bo-too-small-due-to-tiling: SUCCESS (0.002s) |
| Err |
Starting subtest: bo-too-small-due-to-tiling Subtest bo-too-small-due-to-tiling: SUCCESS (0.002s) |
| Dmesg |
<6> [174.769755] Console: switching to colour dummy device 80x25
<6> [174.770260] [IGT] kms_addfb_basic: executing
<7> [174.784213] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [174.788302] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [174.790142] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [174.792015] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000)
<7> [174.793252] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:47]
<7> [174.794846] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:47]
<7> [174.795599] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:47]
<7> [174.816925] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:45:VGA-1]
<7> [174.816973] i915 0000:00:02.0: [drm:intel_crt_detect [i915]] [CONNECTOR:45:VGA-1] force=1
<7> [174.821395] i915 0000:00:02.0: [drm:intel_crt_detect [i915]] CRT detected via hotplug
<7> [174.823321] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus vga] NAK for addr: 0050 w(1)
<7> [174.824639] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus vga] NAK on first message, retry
<7> [174.826446] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus vga] NAK for addr: 0050 w(1)
<7> [174.827977] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus vga
<7> [174.828024] i915 0000:00:02.0: [drm:intel_crt_get_edid [i915]] CRT GMBUS EDID read failed, retry using GPIO bit-banging
<7> [174.829255] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus vga. force bit now 1
<7> [174.831259] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus vga
<7> [174.831312] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus vga. force bit now 0
<7> [174.833164] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:45:VGA-1] probed modes :
<7> [174.833207] [drm:drm_mode_debug_printmodeline] Modeline "1024x768": 60 65000 1024 1048 1184 1344 768 771 777 806 0x40 0xa
<7> [174.833248] [drm:drm_mode_debug_printmodeline] Modeline "800x600": 60 40000 800 840 968 1056 600 601 605 628 0x40 0x5
<7> [174.833289] [drm:drm_mode_debug_printmodeline] Modeline "800x600": 56 36000 800 824 896 1024 600 601 603 625 0x40 0x5
<7> [174.833328] [drm:drm_mode_debug_printmodeline] Modeline "848x480": 60 33750 848 864 976 1088 480 486 494 517 0x40 0x5
<7> [174.833368] [drm:drm_mode_debug_printmodeline] Modeline "640x480": 60 25175 640 656 752 800 480 490 492 525 0x40 0xa
<6> [174.835184] [IGT] kms_addfb_basic: starting subtest bo-too-small-due-to-tiling
<7> [174.836265] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4194304 bytes, have 4190208 bytes)
<7> [174.837771] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<6> [174.838269] [IGT] kms_addfb_basic: finished subtest bo-too-small-due-to-tiling, SUCCESS
<6> [174.844824] [IGT] kms_addfb_basic: exiting, ret=0
<7> [174.849010] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<6> [174.887767] Console: switching to colour frame buffer device 128x48
|