Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Duration | 0.00 seconds |
| Igt-Version |
IGT-Version: 1.28-g619c3f3ff (x86_64) (Linux: 6.7.0-rc8-linus-v6.7-rc8-g610a9b8f49fb+ x86_64) |
| Out |
Using IGT_SRANDOM=1704057364 for randomisation Opened device: /dev/dri/card0 Starting subtest: bo-too-small Subtest bo-too-small: SUCCESS (0.000s) |
| Err |
Starting subtest: bo-too-small Subtest bo-too-small: SUCCESS (0.000s) |
| Dmesg |
<6> [82.247979] Console: switching to colour dummy device 80x25
<6> [82.248016] [IGT] kms_addfb_basic: executing
<7> [82.250620] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [82.251123] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [82.251260] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [82.251519] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000)
<7> [82.251608] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:281]
<7> [82.251699] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:281]
<7> [82.251740] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:281]
<7> [82.258417] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1]
<7> [82.258424] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:246:DP-1]
<7> [82.258585] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1] disconnected
<7> [82.258973] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1]
<7> [82.258976] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:258:HDMI-A-1]
<7> [82.270111] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out after NAK
<7> [82.270294] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] NAK for addr: 0050 w(1)
<7> [82.281149] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out after NAK
<7> [82.281441] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] NAK for addr: 0050 w(1)
<7> [82.332169] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out, falling back to bit banging on pin 10
<7> [82.349257] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [82.349264] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [82.349387] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus tc2. force bit now 1
<7> [82.366267] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [82.366270] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus tc2. force bit now 0
<7> [82.366366] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1] disconnected
<7> [82.366837] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2]
<7> [82.366841] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:264:DP-2]
<7> [82.366986] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2] disconnected
<7> [82.367356] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3]
<7> [82.367359] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:273:DP-3]
<7> [82.367493] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3] disconnected
<7> [82.367976] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:236:eDP-1]
<7> [82.367979] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:236:eDP-1]
<7> [82.368615] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [ENCODER:235:DDI B/PHY B] MST support: port: no, sink: no, modparam: yes
<7> [82.368719] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] source rates: 162000, 216000, 270000, 324000, 432000, 540000, 648000, 810000
<7> [82.368818] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] sink rates: 162000, 270000
<7> [82.368913] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] common rates: 162000, 270000
<7> [82.369037] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] Supported Monitor Refresh rate range is 0 Hz - 0 Hz
<7> [82.369041] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] Assigning EDID-1.4 digital sink color depth as 8 bpc.
<7> [82.369044] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] ELD monitor
<7> [82.369047] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:236:eDP-1] ELD size 20, SAD count 0
<7> [82.369059] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:236:eDP-1] VRR capable: no
<7> [82.369161] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:236:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [82.369946] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] PCON ENCODER DSC DPCD: 00 00 00 00 00 00 00 00 00 00 00 00 00
<7> [82.370063] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:236:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<7> [82.370731] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:236:eDP-1] probed modes :
<7> [82.370734] [drm:drm_mode_debug_printmodeline] Modeline "1920x1080": 60 138780 1920 1968 2000 2080 1080 1083 1088 1112 0x48 0xa
<7> [82.370738] [drm:drm_mode_debug_printmodeline] Modeline "1920x1080": 48 111040 1920 1968 2000 2080 1080 1083 1088 1112 0x40 0xa
<7> [82.370756] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1]
<7> [82.370759] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:246:DP-1]
<7> [82.370918] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:246:DP-1] disconnected
<7> [82.370933] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1]
<7> [82.370936] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:258:HDMI-A-1]
<7> [82.422156] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus tc2] timed out, falling back to bit banging on pin 10
<7> [82.439250] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [82.439254] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [82.439363] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus tc2. force bit now 1
<7> [82.455273] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus tc2
<7> [82.455276] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus tc2. force bit now 0
<7> [82.455372] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:258:HDMI-A-1] disconnected
<7> [82.455394] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2]
<7> [82.455398] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:264:DP-2]
<7> [82.455564] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:264:DP-2] disconnected
<7> [82.455577] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3]
<7> [82.455579] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:273:DP-3]
<7> [82.455711] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:273:DP-3] disconnected
<6> [82.455813] [IGT] kms_addfb_basic: starting subtest bo-too-small
<7> [82.455844] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4198400 bytes, have 4190208 bytes)
<7> [82.455975] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<6> [82.456007] [IGT] kms_addfb_basic: finished subtest bo-too-small, SUCCESS
<6> [82.456228] [IGT] kms_addfb_basic: exiting, ret=0
<7> [82.456413] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<6> [82.496470] Console: switching to colour frame buffer device 240x67
|