Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Duration | 0.00 seconds |
| Igt-Version |
IGT-Version: 1.28-g619c3f3ff (x86_64) (Linux: 6.7.0-rc8-linus-v6.7-rc8-g610a9b8f49fb+ x86_64) |
| Out |
Using IGT_SRANDOM=1704057359 for randomisation Opened device: /dev/dri/card0 Starting subtest: too-wide Subtest too-wide: SUCCESS (0.000s) |
| Err |
Starting subtest: too-wide Subtest too-wide: SUCCESS (0.000s) |
| Dmesg |
<6> [103.978127] Console: switching to colour dummy device 80x25
<6> [103.978199] [IGT] kms_addfb_basic: executing
<7> [103.980559] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [103.981516] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [103.981790] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [103.982235] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000)
<7> [103.982405] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:219]
<7> [103.982573] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:219]
<7> [103.982653] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:219]
<7> [103.990555] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1]
<7> [103.990566] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:194:HDMI-A-1]
<7> [103.990828] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1] disconnected
<7> [103.991426] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1]
<7> [103.991434] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:203:DP-1]
<7> [103.991673] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1] disconnected
<7> [103.992263] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2]
<7> [103.992270] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:212:DP-2]
<7> [103.992501] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2] disconnected
<7> [103.993163] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:185:eDP-1]
<7> [103.993170] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:185:eDP-1]
<7> [103.994042] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] DSC DPCD: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
<7> [103.994716] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [ENCODER:184:DDI A/PHY A] MST support: port: no, sink: no, modparam: yes
<7> [103.994976] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] source rates: 162000, 216000, 270000, 324000, 432000, 540000, 648000, 810000
<7> [103.995173] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] sink rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [103.995357] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] common rates: 162000, 216000, 270000, 324000, 432000, 540000, 810000
<7> [103.995561] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] Supported Monitor Refresh rate range is 0 Hz - 0 Hz
<7> [103.995571] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] Assigning EDID-1.4 digital sink color depth as 10 bpc.
<7> [103.995576] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] ELD monitor
<7> [103.995581] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] ELD size 20, SAD count 0
<7> [103.995602] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:185:eDP-1] VRR capable: no
<7> [103.995796] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:185:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [103.996643] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] PCON ENCODER DSC DPCD: 00 00 00 00 00 00 00 00 00 00 00 00 00
<7> [103.996837] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:185:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<7> [103.997801] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:185:eDP-1] probed modes :
<7> [103.997808] [drm:drm_mode_debug_printmodeline] Modeline "3840x2160": 60 538600 3840 3888 3920 4000 2160 2163 2168 2244 0x48 0xa
<7> [103.997815] [drm:drm_mode_debug_printmodeline] Modeline "3840x2160": 40 359070 3840 3888 3920 4000 2160 2163 2168 2244 0x40 0xa
<7> [103.997843] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1]
<7> [103.997849] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:194:HDMI-A-1]
<7> [103.998063] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1] disconnected
<7> [103.998088] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1]
<7> [103.998093] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:203:DP-1]
<7> [103.998313] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1] disconnected
<7> [103.998335] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2]
<7> [103.998340] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:212:DP-2]
<7> [103.998555] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2] disconnected
<6> [103.998765] [IGT] kms_addfb_basic: starting subtest too-wide
<7> [103.998812] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad pitch 4096 for plane 0
<7> [103.998820] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad pitch 2048 for plane 0
<7> [103.998825] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad pitch 2048 for plane 0
<6> [103.998878] [IGT] kms_addfb_basic: finished subtest too-wide, SUCCESS
<6> [103.999221] [IGT] kms_addfb_basic: exiting, ret=0
<7> [103.999574] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<6> [104.036065] Console: switching to colour frame buffer device 480x135
|