Results for igt@kms_cursor_legacy@basic-flip-after-cursor-atomic

Result: Skip

git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0

DetailValue
Igt-Version 
IGT-Version: 1.28-g2ddd8cac9 (x86_64) (Linux: 6.7.0-rc3-linus-v6.7-rc3-g2cc14f52aeb7+ x86_64)
Out 
Opened device: /dev/dri/card0
No valid crtc/connector combinations found.
No valid crtc/connector combinations found.
No valid crtc/connector combinations found.
No valid crtc/connector combinations found.
No valid crtc/connector combinations found.
No valid crtc/connector combinations found.
No valid crtc/connector combinations found.
Subtest basic-flip-after-cursor-atomic: SKIP (0.000s)
No valid crtc/connector combinations found.
Err 
Subtest basic-flip-after-cursor-atomic: SKIP (0.000s)
Dmesg
<6> [71.097507] [IGT] kms_cursor_legacy: executing
<7> [71.106658] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [71.107107] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [71.107265] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [71.110505] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling PW_2
<7> [71.110683] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [71.110826] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [71.110965] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<7> [71.111154] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1]
<7> [71.111161] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1]
<7> [71.111565] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on
<7> [71.111739] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on
<7> [71.112211] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1] disconnected
<7> [71.112657] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2]
<7> [71.112662] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2]
<7> [71.113128] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [71.113666] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [71.114219] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2
<7> [71.115320] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00
<7> [71.116400] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000
<7> [71.117145] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2] disconnected
<7> [71.117629] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1]
<7> [71.117634] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1]
<7> [71.118048] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.118163] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry
<7> [71.118581] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.118727] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.118731] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [71.118843] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1
<7> [71.123149] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.123153] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0
<7> [71.123271] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1] disconnected
<7> [71.123602] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1]
<7> [71.123607] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1]
<7> [71.123752] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1] disconnected
<7> [71.123766] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2]
<7> [71.123770] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2]
<7> [71.125037] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00
<7> [71.125818] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000
<7> [71.126609] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2] disconnected
<7> [71.126641] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1]
<7> [71.126645] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1]
<7> [71.127060] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.127175] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry
<7> [71.127559] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1)
<7> [71.127730] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.127734] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [71.127846] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1
<7> [71.131882] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [71.131888] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0
<7> [71.132034] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1] disconnected
<6> [71.132409] [IGT] kms_cursor_legacy: exiting, ret=77
<7> [71.132701] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
Created at 2023-11-27 05:45:27