Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.28-g8478eefda (x86_64) (Linux: 6.7.0-rc2-linus-v6.7-rc2-g98b1cc82c4af+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: too-high Subtest too-high: SUCCESS (0.005s) |
| Err |
Starting subtest: too-high Subtest too-high: SUCCESS (0.005s) |
| Dmesg |
<6> [193.468556] Console: switching to colour dummy device 80x25
<6> [193.469060] [IGT] kms_addfb_basic: executing
<7> [193.483496] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [193.487600] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [193.489404] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [193.491471] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000)
<7> [193.492544] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:47]
<7> [193.494100] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:47]
<7> [193.495212] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:47]
<7> [193.515818] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:45:VGA-1]
<7> [193.515865] i915 0000:00:02.0: [drm:intel_crt_detect [i915]] [CONNECTOR:45:VGA-1] force=1
<7> [193.531580] i915 0000:00:02.0: [drm:intel_crt_detect [i915]] CRT detected via hotplug
<7> [193.532837] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus vga] NAK for addr: 0050 w(1)
<7> [193.533898] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus vga] NAK on first message, retry
<7> [193.535615] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus vga] NAK for addr: 0050 w(1)
<7> [193.536915] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus vga
<7> [193.536959] i915 0000:00:02.0: [drm:intel_crt_get_edid [i915]] CRT GMBUS EDID read failed, retry using GPIO bit-banging
<7> [193.538327] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus vga. force bit now 1
<7> [193.540336] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus vga
<7> [193.540377] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus vga. force bit now 0
<7> [193.541806] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:45:VGA-1] probed modes :
<7> [193.541838] [drm:drm_mode_debug_printmodeline] Modeline "1024x768": 60 65000 1024 1048 1184 1344 768 771 777 806 0x40 0xa
<7> [193.541864] [drm:drm_mode_debug_printmodeline] Modeline "800x600": 60 40000 800 840 968 1056 600 601 605 628 0x40 0x5
<7> [193.541888] [drm:drm_mode_debug_printmodeline] Modeline "800x600": 56 36000 800 824 896 1024 600 601 603 625 0x40 0x5
<7> [193.541912] [drm:drm_mode_debug_printmodeline] Modeline "848x480": 60 33750 848 864 976 1088 480 486 494 517 0x40 0x5
<7> [193.541935] [drm:drm_mode_debug_printmodeline] Modeline "640x480": 60 25175 640 656 752 800 480 490 492 525 0x40 0xa
<6> [193.542993] [IGT] kms_addfb_basic: starting subtest too-high
<7> [193.543486] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4198400 bytes, have 4194304 bytes)
<7> [193.544873] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<7> [193.545105] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4198400 bytes, have 4194304 bytes)
<7> [193.546469] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<7> [193.546719] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4198400 bytes, have 4194304 bytes)
<7> [193.548101] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<6> [193.548725] [IGT] kms_addfb_basic: finished subtest too-high, SUCCESS
<6> [193.552086] [IGT] kms_addfb_basic: exiting, ret=0
<7> [193.555603] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<6> [193.598383] Console: switching to colour frame buffer device 128x48
|