Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.28-g5e82a8ee4 (x86_64) (Linux: 6.6.0-linus-v6.6-gffc253263a13+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: basic-auth Subtest basic-auth: SUCCESS (0.001s) |
| Err |
Starting subtest: basic-auth Subtest basic-auth: SUCCESS (0.001s) |
| Dmesg |
<6> [38.375891] snd_hda_codec_realtek hdaudioC0D0: autoconfig for ALC283: line_outs=1 (0x21/0x0/0x0/0x0/0x0) type:hp
<6> [38.375900] snd_hda_codec_realtek hdaudioC0D0: speaker_outs=0 (0x0/0x0/0x0/0x0/0x0)
<6> [38.375904] snd_hda_codec_realtek hdaudioC0D0: hp_outs=0 (0x0/0x0/0x0/0x0/0x0)
<6> [38.375907] snd_hda_codec_realtek hdaudioC0D0: mono: mono_out=0x0
<6> [38.375910] snd_hda_codec_realtek hdaudioC0D0: inputs:
<6> [38.375913] snd_hda_codec_realtek hdaudioC0D0: Mic=0x12
<7> [38.396206] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] timed out, falling back to bit banging on pin 4
<7> [38.399597] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [38.399607] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging
<7> [38.399819] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1
<7> [38.403287] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc
<7> [38.403296] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0
<7> [38.403503] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:114:HDMI-A-1] disconnected
<7> [38.403511] [drm:drm_client_modeset_probe] No connectors reported connected with modes
<7> [38.403517] [drm:drm_client_modeset_probe] connector 95 enabled? no
<7> [38.403522] [drm:drm_client_modeset_probe] connector 108 enabled? no
<7> [38.403526] [drm:drm_client_modeset_probe] connector 114 enabled? no
<7> [38.403563] [drm:drm_client_firmware_config.isra.0] Not using firmware configuration
<7> [38.403573] [drm:drm_client_modeset_probe] picking CRTCs for 16384x16384 config
<7> [38.403593] i915 0000:00:02.0: [drm:__drm_fb_helper_initial_config_and_unlock] test CRTC 0 primary plane
<6> [38.403603] i915 0000:00:02.0: [drm] Cannot find any crtc or sizes
<6> [38.420613] [IGT] core_auth: executing
<7> [38.426989] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [38.427927] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [38.437582] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<6> [38.438074] [IGT] core_auth: starting subtest basic-auth
<7> [38.438198] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<6> [38.439160] [IGT] core_auth: finished subtest basic-auth, SUCCESS
<6> [38.439282] [IGT] core_auth: exiting, ret=0
<7> [38.439669] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [38.449232] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port B
<7> [38.449525] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port B
<7> [38.449749] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port B
<7> [38.449957] i915 0000:00:02.0: [drm:i915_audio_component_get_eld [i915]] Not valid for port C
|