Results for igt@kms_addfb_basic@bo-too-small-due-to-tiling

Result: Pass

git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0

Detail	Value
Igt-Version	IGT-Version: 1.28-g08e87a32f (x86_64) (Linux: 6.6.0-rc6-linus-v6.6-rc6-g58720809f527+ x86_64)
Out	Opened device: /dev/dri/card0 Starting subtest: bo-too-small-due-to-tiling Subtest bo-too-small-due-to-tiling: SUCCESS (0.000s)
Err	Starting subtest: bo-too-small-due-to-tiling Subtest bo-too-small-due-to-tiling: SUCCESS (0.000s)
Dmesg	<6> [90.040888] [IGT] kms_addfb_basic: executing <7> [90.048608] i915 0000:00:02.0: [drm:i915_gem_open [i915]] <7> [90.049030] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc] <7> [90.049187] i915 0000:00:02.0: [drm:i915_gem_open [i915]] <7> [90.049397] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000) <7> [90.049528] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:118] <7> [90.049718] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:118] <7> [90.049784] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:118] <7> [90.053556] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1] <7> [90.053563] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1] <7> [90.053709] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.054186] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.054333] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1] disconnected <7> [90.054780] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2] <7> [90.054785] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2] <7> [90.054946] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.055422] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off <7> [90.056030] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00 <7> [90.056604] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2 <7> [90.057723] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00 <7> [90.058803] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000 <7> [90.059512] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling PW_2 <7> [90.059667] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off <7> [90.059802] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6 <7> [90.059933] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02 <7> [90.060538] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.060677] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2] disconnected <7> [90.061093] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1] <7> [90.061098] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1] <7> [90.061220] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.063412] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.063731] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry <7> [90.064428] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.064954] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.064959] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging <7> [90.065097] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1 <7> [90.089177] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.089181] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0 <7> [90.089291] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.089421] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1] disconnected <7> [90.089806] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1] <7> [90.089811] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1] <7> [90.089961] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.090450] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.090594] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:95:DP-1] disconnected <7> [90.090634] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2] <7> [90.090638] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2] <7> [90.090799] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.091260] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off <7> [90.091787] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00 <7> [90.092339] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2 <7> [90.093517] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00 <7> [90.094517] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000 <7> [90.095267] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling PW_2 <7> [90.095418] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off <7> [90.095606] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6 <7> [90.095799] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02 <7> [90.096380] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.096541] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:107:DP-2] disconnected <7> [90.096559] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1] <7> [90.096576] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1] <7> [90.096723] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.097826] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.098361] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry <7> [90.099054] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.099578] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.099605] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging <7> [90.099786] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1 <7> [90.124388] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.124393] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0 <7> [90.124529] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.124724] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:113:HDMI-A-1] disconnected <6> [90.124851] [IGT] kms_addfb_basic: starting subtest bo-too-small-due-to-tiling <7> [90.124916] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4194304 bytes, have 4190208 bytes) <7> [90.125047] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer <6> [90.125114] [IGT] kms_addfb_basic: finished subtest bo-too-small-due-to-tiling, SUCCESS <6> [90.125358] [IGT] kms_addfb_basic: exiting, ret=0 <7> [90.125637] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]

Created at 2023-10-15 23:44:09