Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.28-gd991240f6 (x86_64) (Linux: 6.6.0-rc3-linus-v6.6-rc3-g6465e260f487+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: addfb25-y-tiled-small-legacy Subtest addfb25-y-tiled-small-legacy: SUCCESS (0.000s) |
| Err |
Starting subtest: addfb25-y-tiled-small-legacy Subtest addfb25-y-tiled-small-legacy: SUCCESS (0.000s) |
| Dmesg |
<6> [149.575218] Console: switching to colour dummy device 80x25
<6> [149.575349] [IGT] kms_addfb_basic: executing
<7> [149.580966] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [149.582273] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [149.582740] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [149.583467] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000)
<7> [149.583766] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:266]
<7> [149.584069] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:266]
<7> [149.584203] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:266]
<7> [149.601495] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:248:DP-1]
<7> [149.601515] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:248:DP-1]
<7> [149.601931] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:248:DP-1] disconnected
<7> [149.602970] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:257:HDMI-A-1]
<7> [149.602984] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:257:HDMI-A-1]
<7> [149.603339] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:257:HDMI-A-1] disconnected
<7> [149.604352] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:263:HDMI-A-2]
<7> [149.604364] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:263:HDMI-A-2]
<7> [149.604734] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:263:HDMI-A-2] disconnected
<7> [149.606105] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:239:eDP-1]
<7> [149.606119] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:239:eDP-1]
<7> [149.607064] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [ENCODER:238:DDI A/PHY A] MST support: port: no, sink: no, modparam: yes
<7> [149.607365] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] source rates: 162000, 216000, 270000, 324000, 432000, 540000
<7> [149.607684] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] sink rates: 162000, 270000, 540000
<7> [149.607977] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] common rates: 162000, 270000, 540000
<7> [149.608307] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:239:eDP-1] Assigning DFP sink color depth as 8 bpc.
<7> [149.608320] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:239:eDP-1] ELD monitor
<7> [149.608328] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:239:eDP-1] ELD size 20, SAD count 0
<7> [149.608360] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:239:eDP-1] VRR capable: no
<7> [149.608668] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:239:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [149.609773] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] PCON ENCODER DSC DPCD: 00 00 00 00 00 00 00 00 00 00 00 00 00
<7> [149.610084] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:239:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<7> [149.611165] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:239:eDP-1] probed modes :
<7> [149.611178] [drm:drm_mode_debug_printmodeline] Modeline "3200x1800": 60 361310 3200 3248 3280 3316 1800 1802 1807 1816 0x48 0xa
<7> [149.611189] [drm:drm_mode_debug_printmodeline] Modeline "3200x1800": 52 361310 3200 3248 3280 3424 1800 1802 1807 2045 0x40 0xa
<7> [149.611244] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:248:DP-1]
<7> [149.611256] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:248:DP-1]
<7> [149.611620] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:248:DP-1] disconnected
<7> [149.611664] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:257:HDMI-A-1]
<7> [149.611674] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:257:HDMI-A-1]
<7> [149.612007] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:257:HDMI-A-1] disconnected
<7> [149.612045] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:263:HDMI-A-2]
<7> [149.612055] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:263:HDMI-A-2]
<7> [149.612383] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:263:HDMI-A-2] disconnected
<6> [149.612953] [IGT] kms_addfb_basic: starting subtest addfb25-y-tiled-small-legacy
<7> [149.613066] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4194304 bytes, have 4190208 bytes)
<7> [149.613396] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<6> [149.613498] [IGT] kms_addfb_basic: finished subtest addfb25-y-tiled-small-legacy, SUCCESS
<6> [149.614157] [IGT] kms_addfb_basic: exiting, ret=0
<7> [149.614802] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<6> [149.617705] pcieport 0000:00:1c.4: AER: Corrected error received: 0000:02:00.0
<4> [149.617723] nvme 0000:02:00.0: PCIe Bus Error: severity=Corrected, type=Physical Layer, (Receiver ID)
<4> [149.617728] nvme 0000:02:00.0: device [15b7:5006] error status/mask=00000001/0000e000
<4> [149.617734] nvme 0000:02:00.0: [ 0] RxErr (First)
<6> [149.644392] pcieport 0000:00:1c.4: AER: Corrected error received: 0000:02:00.0
<4> [149.644408] nvme 0000:02:00.0: PCIe Bus Error: severity=Corrected, type=Physical Layer, (Receiver ID)
<4> [149.644412] nvme 0000:02:00.0: device [15b7:5006] error status/mask=00000001/0000e000
<4> [149.644416] nvme 0000:02:00.0: [ 0] RxErr (First)
<6> [149.650571] Console: switching to colour frame buffer device 400x112
|