Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.28-gd991240f6 (x86_64) (Linux: 6.6.0-rc3-linus-v6.6-rc3-g6465e260f487+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.118s) |
| Err |
Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.118s) |
| Dmesg |
<6> [100.016677] Console: switching to colour dummy device 80x25
<6> [100.016746] [IGT] i915_hangman: executing
<7> [100.018181] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [100.019211] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [100.019627] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [100.020344] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<5> [100.023877] i915 0000:00:02.0: [drm] rcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [100.025172] i915 0000:00:02.0: [drm] bcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [100.025829] i915 0000:00:02.0: [drm] vcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [100.026694] i915 0000:00:02.0: [drm] vecs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<6> [100.027072] [IGT] i915_hangman: starting subtest error-state-basic
<7> [100.027122] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [100.118077] i915 0000:00:02.0: [drm] GPU HANG: ecode 12:0:00000000
<5> [100.120274] i915 0000:00:02.0: [drm] Resetting chip for Manually reset engine mask to 1
<6> [100.122859] i915 0000:00:02.0: [drm] GT0: GuC firmware i915/tgl_guc_70.bin version 70.5.1
<6> [100.122863] i915 0000:00:02.0: [drm] GT0: HuC firmware i915/tgl_huc.bin version 7.9.3
<7> [100.127936] i915 0000:00:02.0: [drm:intel_guc_fw_upload [i915]] GT0: GUC: init took 1ms, freq = 750MHz, before = 750MHz, status = 0x8002F0EC, count = 0, ret = 0
<7> [100.131017] i915 0000:00:02.0: [drm:guc_enable_communication [i915]] GT0: GUC: communication enabled
<6> [100.133217] i915 0000:00:02.0: [drm] GT0: HuC: authenticated for all workloads
<6> [100.138214] i915 0000:00:02.0: [drm] GT0: GUC: submission enabled
<6> [100.138218] i915 0000:00:02.0: [drm] GT0: GUC: SLPC enabled
<7> [100.144570] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [100.145113] [IGT] i915_hangman: finished subtest error-state-basic, SUCCESS
<6> [100.150020] [IGT] i915_hangman: exiting, ret=0
<7> [100.150822] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [100.152484] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [100.153099] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [100.153304] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [100.153485] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [100.153687] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [100.153857] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<6> [100.191054] Console: switching to colour frame buffer device 480x135
|