Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.27.1-g605d12880 (x86_64) (Linux: 6.6.0-rc1-linus-v6.6-rc1-g0bb80ecc33a8+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: bo-too-small-due-to-tiling Subtest bo-too-small-due-to-tiling: SUCCESS (0.000s) |
| Err |
Starting subtest: bo-too-small-due-to-tiling Subtest bo-too-small-due-to-tiling: SUCCESS (0.000s) |
| Dmesg |
<6> [105.218042] Console: switching to colour dummy device 80x25
<6> [105.218112] [IGT] kms_addfb_basic: executing
<7> [105.221275] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [105.222426] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [105.222760] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [105.223323] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] bad framebuffer format .... little-endian (0x00000000)
<7> [105.223533] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:220]
<7> [105.223830] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:220]
<7> [105.223945] i915 0000:00:02.0: [drm:drm_mode_addfb2] [FB:220]
<7> [105.232025] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1]
<7> [105.232037] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:194:HDMI-A-1]
<7> [105.232261] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1] disconnected
<7> [105.232843] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1]
<7> [105.232851] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:203:DP-1]
<7> [105.233138] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1] disconnected
<7> [105.233852] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2]
<7> [105.233861] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:212:DP-2]
<7> [105.234133] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2] disconnected
<7> [105.234987] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:185:eDP-1]
<7> [105.234997] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:185:eDP-1]
<7> [105.236028] i915 0000:00:02.0: [drm:intel_dp_get_dsc_sink_cap [i915]] DSC DPCD: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
<7> [105.236296] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] FEC CAPABILITY: 0
<7> [105.237101] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [ENCODER:184:DDI A/PHY A] MST support: port: no, sink: no, modparam: yes
<7> [105.237369] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] source rates: 162000, 216000, 270000, 324000, 432000, 540000, 648000, 810000
<7> [105.237625] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] sink rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [105.237864] i915 0000:00:02.0: [drm:intel_dp_print_rates [i915]] common rates: 162000, 216000, 270000, 324000, 432000, 540000, 810000
<7> [105.238158] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] Supported Monitor Refresh rate range is 0 Hz - 0 Hz
<7> [105.238172] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] Assigning EDID-1.4 digital sink color depth as 10 bpc.
<7> [105.238181] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] ELD monitor
<7> [105.238189] i915 0000:00:02.0: [drm:update_display_info] [CONNECTOR:185:eDP-1] ELD size 20, SAD count 0
<7> [105.238219] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:185:eDP-1] VRR capable: no
<7> [105.238479] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:185:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [105.239515] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] PCON ENCODER DSC DPCD: 00 00 00 00 00 00 00 00 00 00 00 00 00
<7> [105.239805] i915 0000:00:02.0: [drm:intel_dp_set_edid [i915]] [CONNECTOR:185:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<7> [105.240870] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:185:eDP-1] probed modes :
<7> [105.240882] [drm:drm_mode_debug_printmodeline] Modeline "3840x2160": 60 538600 3840 3888 3920 4000 2160 2163 2168 2244 0x48 0xa
<7> [105.240893] [drm:drm_mode_debug_printmodeline] Modeline "3840x2160": 40 359070 3840 3888 3920 4000 2160 2163 2168 2244 0x40 0xa
<7> [105.240945] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1]
<7> [105.240955] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:194:HDMI-A-1]
<7> [105.241276] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:194:HDMI-A-1] disconnected
<7> [105.241316] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1]
<7> [105.241326] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:203:DP-1]
<7> [105.241653] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:203:DP-1] disconnected
<7> [105.241715] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2]
<7> [105.241726] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:212:DP-2]
<7> [105.242050] [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:212:DP-2] disconnected
<6> [105.242271] [IGT] kms_addfb_basic: starting subtest bo-too-small-due-to-tiling
<7> [105.242399] i915 0000:00:02.0: [drm:intel_fill_fb_info [i915]] fb too big for bo (need 4194304 bytes, have 4190208 bytes)
<7> [105.242772] i915 0000:00:02.0: [drm:drm_internal_framebuffer_create] could not create framebuffer
<6> [105.242895] [IGT] kms_addfb_basic: finished subtest bo-too-small-due-to-tiling, SUCCESS
<6> [105.243423] [IGT] kms_addfb_basic: exiting, ret=0
<7> [105.244075] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<6> [105.277274] Console: switching to colour frame buffer device 480x135
|