Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.27.1-g3adb0b19c (x86_64) (Linux: 6.5.0-rc4-linus-v6.5-rc4-g5d0c230f1de8+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.123s) |
| Err |
Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.123s) |
| Dmesg |
<6> [99.177211] Console: switching to colour dummy device 80x25
<6> [99.177266] [IGT] i915_hangman: executing
<7> [99.179525] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [99.180168] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [99.180367] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [99.180757] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<5> [99.184090] i915 0000:00:02.0: [drm] rcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [99.185313] i915 0000:00:02.0: [drm] bcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [99.185988] i915 0000:00:02.0: [drm] vcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [99.186686] i915 0000:00:02.0: [drm] vecs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<6> [99.187129] [IGT] i915_hangman: starting subtest error-state-basic
<7> [99.187192] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [99.283282] i915 0000:00:02.0: [drm] GPU HANG: ecode 12:0:00000000
<5> [99.285691] i915 0000:00:02.0: [drm] Resetting chip for Manually reset engine mask to 1
<6> [99.288284] i915 0000:00:02.0: [drm] GT0: GuC firmware i915/tgl_guc_70.bin version 70.5.1
<6> [99.288289] i915 0000:00:02.0: [drm] GT0: HuC firmware i915/tgl_huc.bin version 7.9.3
<7> [99.293147] i915 0000:00:02.0: [drm:intel_guc_fw_upload [i915]] GT0: GUC: init took 1ms, freq = 750MHz, before = 750MHz, status = 0x8002F0EC, count = 0, ret = 0
<7> [99.296219] i915 0000:00:02.0: [drm:guc_enable_communication [i915]] GT0: GUC: communication enabled
<6> [99.299256] i915 0000:00:02.0: [drm] GT0: HuC: authenticated for all workloads
<6> [99.303424] i915 0000:00:02.0: [drm] GT0: GUC: submission enabled
<6> [99.303429] i915 0000:00:02.0: [drm] GT0: GUC: SLPC enabled
<7> [99.309372] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [99.309948] [IGT] i915_hangman: finished subtest error-state-basic, SUCCESS
<6> [99.314882] [IGT] i915_hangman: exiting, ret=0
<7> [99.315675] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [99.317322] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [99.317936] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [99.318142] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.318328] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [99.318544] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.318725] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [99.338562] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [99.338928] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [99.339212] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<7> [99.342241] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [99.342512] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [99.342808] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.343063] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [99.343301] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.343551] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [99.354901] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [99.355174] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [99.355416] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<6> [99.356114] Console: switching to colour frame buffer device 480x135
<7> [99.357218] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [99.357559] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [99.357948] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.358229] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [99.358521] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.358863] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [99.371599] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [99.371819] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [99.372011] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
|