Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.27.1-g354c536a4 (x86_64) (Linux: 6.5.0-rc3-linus-v6.5-rc3-g6eaae1980760+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.116s) |
| Err |
Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.116s) |
| Dmesg |
<6> [98.910614] Console: switching to colour dummy device 80x25
<6> [98.910665] [IGT] i915_hangman: executing
<7> [98.913451] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [98.914034] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [98.914232] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [98.914628] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<5> [98.917815] i915 0000:00:02.0: [drm] rcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [98.918981] i915 0000:00:02.0: [drm] bcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [98.919636] i915 0000:00:02.0: [drm] vcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [98.920272] i915 0000:00:02.0: [drm] vecs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<6> [98.920662] [IGT] i915_hangman: starting subtest error-state-basic
<7> [98.920713] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [99.009484] i915 0000:00:02.0: [drm] GPU HANG: ecode 12:0:00000000
<5> [99.011746] i915 0000:00:02.0: [drm] Resetting chip for Manually reset engine mask to 1
<6> [99.014425] i915 0000:00:02.0: [drm] GT0: GuC firmware i915/tgl_guc_70.bin version 70.5.1
<6> [99.014430] i915 0000:00:02.0: [drm] GT0: HuC firmware i915/tgl_huc.bin version 7.9.3
<7> [99.019294] i915 0000:00:02.0: [drm:intel_guc_fw_upload [i915]] GT0: GUC: init took 1ms, freq = 750MHz, before = 750MHz, status = 0x8002F0EC, count = 0, ret = 0
<7> [99.023412] i915 0000:00:02.0: [drm:guc_enable_communication [i915]] GT0: GUC: communication enabled
<6> [99.026432] i915 0000:00:02.0: [drm] GT0: HuC: authenticated for all workloads
<6> [99.030597] i915 0000:00:02.0: [drm] GT0: GUC: submission enabled
<6> [99.030602] i915 0000:00:02.0: [drm] GT0: GUC: SLPC enabled
<7> [99.036593] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [99.037087] [IGT] i915_hangman: finished subtest error-state-basic, SUCCESS
<6> [99.042013] [IGT] i915_hangman: exiting, ret=0
<7> [99.042817] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [99.045050] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [99.045679] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [99.045907] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.046171] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [99.046381] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.046560] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [99.066124] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [99.066552] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [99.066847] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<7> [99.069603] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [99.069900] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [99.070191] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.070483] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [99.070771] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.071140] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [99.083003] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [99.083303] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [99.083578] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<6> [99.084249] Console: switching to colour frame buffer device 480x135
<7> [99.085071] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [99.085314] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [99.085628] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.085915] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [99.086160] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [99.086433] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [99.099453] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [99.099684] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [99.099882] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
|