Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.27.1-gfaa966f69 (x86_64) (Linux: 6.5.0-rc2-linus-v6.5-rc2-gfdf0eaf11452+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: basic Setup 1025 batches in 2681.47ms engine[0]: 2 cycles engine[1]: 2 cycles engine[3]: 2 cycles engine[2]: 2 cycles Total: 8 cycles Subtest basic: SUCCESS (6.017s) |
| Err |
Starting subtest: basic Subtest basic: SUCCESS (6.017s) |
| Dmesg |
<6> [69.124087] Console: switching to colour dummy device 80x25
<6> [69.124227] [IGT] gem_exec_gttfill: executing
<7> [69.136796] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [69.138087] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [69.138540] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [69.139321] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<6> [69.156579] [IGT] gem_exec_gttfill: starting subtest basic
<7> [69.156975] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<6> [69.157902] gem_exec_gttfil (999): drop_caches: 4
<7> [69.158066] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x00000070 [0x00000070]
<7> [69.944519] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x00000070 [0x00000070]
<7> [70.020982] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x0000005c [0x0000005c]
<7> [75.050081] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x0000005c [0x0000005c]
<6> [75.173398] [IGT] gem_exec_gttfill: finished subtest basic, SUCCESS
<6> [75.284836] [IGT] gem_exec_gttfill: exiting, ret=0
<7> [75.285241] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [75.286633] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [75.286980] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [75.287340] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.287701] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [75.288037] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.288363] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [75.288694] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY C Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.289014] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY C already enabled, won't reprogram it.
<7> [75.300941] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [75.301322] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [75.301675] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<7> [75.304666] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [75.305014] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [75.305369] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.305735] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [75.306067] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.306434] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [75.306753] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY C Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.307072] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY C already enabled, won't reprogram it.
<6> [75.313138] pcieport 0000:00:1c.4: AER: Corrected error received: 0000:02:00.0
<4> [75.313155] nvme 0000:02:00.0: PCIe Bus Error: severity=Corrected, type=Physical Layer, (Receiver ID)
<4> [75.313159] nvme 0000:02:00.0: device [15b7:5006] error status/mask=00000001/0000e000
<4> [75.313163] nvme 0000:02:00.0: [ 0] RxErr (First)
<7> [75.317602] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [75.317982] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [75.318295] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<6> [75.319236] Console: switching to colour frame buffer device 400x112
<7> [75.320350] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [75.320777] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [75.321143] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.321497] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [75.321815] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.322134] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [75.322471] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY C Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [75.322793] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY C already enabled, won't reprogram it.
<6> [75.333450] pcieport 0000:00:1c.4: AER: Corrected error received: 0000:02:00.0
<4> [75.333468] nvme 0000:02:00.0: PCIe Bus Error: severity=Corrected, type=Physical Layer, (Receiver ID)
<4> [75.333472] nvme 0000:02:00.0: device [15b7:5006] error status/mask=00000001/0000e000
<4> [75.333476] nvme 0000:02:00.0: [ 0] RxErr (First)
<7> [75.334284] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [75.334695] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [75.335016] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
|