Result:
git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0
| Detail | Value |
|---|---|
| Igt-Version |
IGT-Version: 1.27.1-g766edf969 (x86_64) (Linux: 6.4.0-rc4-linus-v6.4-rc4-g7877cb91f108+ x86_64) |
| Out |
Opened device: /dev/dri/card0 Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.116s) |
| Err |
Starting subtest: error-state-basic Subtest error-state-basic: SUCCESS (0.116s) |
| Dmesg |
<6> [124.993910] Console: switching to colour dummy device 80x25
<6> [124.993964] [IGT] i915_hangman: executing
<7> [124.996357] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [124.996925] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x0000005c [0x0000005c]
<7> [124.997092] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<7> [124.997476] i915 0000:00:02.0: [drm:i915_gem_open [i915]]
<5> [125.000705] i915 0000:00:02.0: [drm] rcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [125.001921] i915 0000:00:02.0: [drm] bcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [125.002677] i915 0000:00:02.0: [drm] vcs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<5> [125.003419] i915 0000:00:02.0: [drm] vecs0 heartbeat interval adjusted to a non-default value which may downgrade individual engine resets to full GPU resets!
<6> [125.003836] [IGT] i915_hangman: starting subtest error-state-basic
<7> [125.003902] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [125.092545] i915 0000:00:02.0: [drm] GPU HANG: ecode 12:0:00000000
<5> [125.094817] i915 0000:00:02.0: [drm] Resetting chip for Manually reset engine mask to 1
<6> [125.097392] i915 0000:00:02.0: [drm] GT0: GuC firmware i915/tgl_guc_70.bin version 70.5.1
<6> [125.097397] i915 0000:00:02.0: [drm] GT0: HuC firmware i915/tgl_huc.bin version 7.9.3
<7> [125.102451] i915 0000:00:02.0: [drm:intel_guc_fw_upload [i915]] GT0: GUC: init took 1ms, freq = 750MHz, before = 750MHz, status = 0x8002F0EC, count = 0, ret = 0
<7> [125.105537] i915 0000:00:02.0: [drm:guc_enable_communication [i915]] GT0: GUC: communication enabled
<6> [125.107655] i915 0000:00:02.0: [drm] GT0: HuC: authenticated!
<6> [125.112736] i915 0000:00:02.0: [drm] GT0: GUC: submission enabled
<6> [125.112740] i915 0000:00:02.0: [drm] GT0: GUC: SLPC enabled
<7> [125.119767] i915 0000:00:02.0: [drm:error_state_write [i915]] Resetting error state
<6> [125.125100] [IGT] i915_hangman: exiting, ret=0
<7> [125.125943] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]
<7> [125.127635] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [125.128246] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [125.128461] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [125.128679] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [125.128852] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [125.129023] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [125.148532] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [125.148873] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [125.149128] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<7> [125.151887] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [125.152114] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [125.152377] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [125.152612] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [125.152856] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [125.153137] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [125.165417] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [125.165741] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [125.165971] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<6> [125.166600] Console: switching to colour frame buffer device 480x135
<7> [125.167592] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off
<7> [125.167906] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00
<7> [125.168236] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY A Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [125.168559] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY A already enabled, won't reprogram it.
<7> [125.168906] i915 0000:00:02.0: [drm:icl_verify_procmon_ref_values [i915]] Combo PHY B Voltage/Process Info : 0.85V dot0 (low-voltage)
<7> [125.169215] i915 0000:00:02.0: [drm:icl_combo_phys_init [i915]] Combo PHY B already enabled, won't reprogram it.
<7> [125.181831] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7> [125.182037] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7> [125.182214] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
|