Results for igt@kms_cursor_legacy@basic-flip-before-cursor-atomic

Result: Skip

git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0

Detail	Value
Igt-Version	IGT-Version: 1.27.1-gf9d49501e (x86_64) (Linux: 6.3.0-rc2-linus-v6.3-rc2-geeac8ede1755+ x86_64)
Out	No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. Subtest basic-flip-before-cursor-atomic: SKIP (0.000s) No valid crtc/connector combinations found.
Err	Subtest basic-flip-before-cursor-atomic: SKIP (0.000s)
Dmesg	<6> [90.578316] [IGT] kms_cursor_legacy: executing <7> [90.586405] i915 0000:00:02.0: [drm:i915_gem_open [i915]] <7> [90.586762] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x0000005c [0x0000005c] <7> [90.586885] i915 0000:00:02.0: [drm:i915_gem_open [i915]] <7> [90.591156] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] <7> [90.591207] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1] <7> [90.591346] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.591798] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.591922] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] disconnected <7> [90.592522] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] <7> [90.592537] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2] <7> [90.592654] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.593127] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off <7> [90.593666] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00 <7> [90.594222] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2 <7> [90.595428] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00 <7> [90.596546] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000 <7> [90.597071] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling PW_2 <7> [90.597230] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off <7> [90.597358] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6 <7> [90.597481] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02 <7> [90.598056] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.598194] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] disconnected <7> [90.598742] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] <7> [90.598756] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1] <7> [90.598874] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.600006] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.600117] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry <7> [90.600823] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.601341] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.601349] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging <7> [90.601478] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1 <7> [90.625480] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.625486] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0 <7> [90.625620] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.625743] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] disconnected <7> [90.626112] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] <7> [90.626126] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1] <7> [90.626300] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.626811] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.626953] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] disconnected <7> [90.627006] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] <7> [90.627025] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2] <7> [90.627163] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.627720] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off <7> [90.628220] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00 <7> [90.628783] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2 <7> [90.629903] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00 <7> [90.631048] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000 <7> [90.631724] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling PW_2 <7> [90.631873] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off <7> [90.631999] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6 <7> [90.632122] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02 <7> [90.632755] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.632896] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] disconnected <7> [90.632926] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] <7> [90.632939] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1] <7> [90.633051] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.634126] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.634302] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry <7> [90.635053] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.635581] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.635585] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging <7> [90.635721] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1 <7> [90.664170] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.664183] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0 <7> [90.664293] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.664420] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] disconnected <6> [90.664843] [IGT] kms_cursor_legacy: exiting, ret=77 <7> [90.665191] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]

Created at 2023-03-14 04:19:55