Results for igt@kms_cursor_legacy@basic-flip-after-cursor-legacy

Result: Skip

git-log-oneline igt_runner0 run0 runtimes0 results0.json boot0 dmesg0

Detail	Value
Igt-Version	IGT-Version: 1.27.1-gf9d49501e (x86_64) (Linux: 6.3.0-rc2-linus-v6.3-rc2-geeac8ede1755+ x86_64)
Out	No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. No valid crtc/connector combinations found. Subtest basic-flip-after-cursor-legacy: SKIP (0.000s) No valid crtc/connector combinations found.
Err	Subtest basic-flip-after-cursor-legacy: SKIP (0.000s)
Dmesg	<6> [90.178784] [IGT] kms_cursor_legacy: executing <7> [90.187639] i915 0000:00:02.0: [drm:i915_gem_open [i915]] <7> [90.188010] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x0000005c [0x0000005c] <7> [90.188141] i915 0000:00:02.0: [drm:i915_gem_open [i915]] <7> [90.192369] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] <7> [90.192387] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1] <7> [90.192522] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.192983] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.193117] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] disconnected <7> [90.193779] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] <7> [90.193793] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2] <7> [90.193918] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.194475] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off <7> [90.194928] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00 <7> [90.195514] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2 <7> [90.196669] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00 <7> [90.197803] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000 <7> [90.198600] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling PW_2 <7> [90.198747] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off <7> [90.198873] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6 <7> [90.198995] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02 <7> [90.199633] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.199802] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] disconnected <7> [90.200357] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] <7> [90.200371] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1] <7> [90.200485] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.201673] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.201793] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry <7> [90.202597] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.203036] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.203041] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging <7> [90.203144] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1 <7> [90.231541] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.231546] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0 <7> [90.231653] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.231779] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] disconnected <7> [90.232174] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] <7> [90.232201] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:95:DP-1] <7> [90.232357] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.232812] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.232966] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:95:DP-1] disconnected <7> [90.232994] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] <7> [90.233006] i915 0000:00:02.0: [drm:intel_dp_detect [i915]] [CONNECTOR:107:DP-2] <7> [90.233136] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.233639] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling DC_off <7> [90.234130] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 02 to 00 <7> [90.234718] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling PW_2 <7> [90.235829] i915 0000:00:02.0: [drm:drm_dp_read_dpcd_caps [drm_display_helper]] AUX C/DDI C/PHY C: DPCD: 12 0a 82 01 00 03 01 81 00 01 00 00 00 00 00 <7> [90.236932] i915 0000:00:02.0: [drm:drm_dp_read_desc [drm_display_helper]] AUX C/DDI C/PHY C: DP branch: OUI 00-60-37 dev-ID 3355N2 HW-rev 1.0 SW-rev 1.3 quirks 0x0000 <7> [90.237589] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling PW_2 <7> [90.237734] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off <7> [90.237861] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6 <7> [90.237981] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02 <7> [90.238589] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.238744] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:107:DP-2] disconnected <7> [90.238773] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] <7> [90.238786] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:113:HDMI-A-1] <7> [90.238897] i915 0000:00:02.0: [drm:intel_power_well_enable [i915]] enabling always-on <7> [90.239644] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.239749] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK on first message, retry <7> [90.240537] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpc] NAK for addr: 0050 w(1) <7> [90.240979] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.240983] i915 0000:00:02.0: [drm:intel_hdmi_set_edid [i915]] HDMI GMBUS EDID read failed, retry using GPIO bit-banging <7> [90.241086] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] enabling bit-banging on i915 gmbus dpc. force bit now 1 <7> [90.271145] [drm:drm_do_probe_ddc_edid] drm: skipping non-existent adapter i915 gmbus dpc <7> [90.271150] i915 0000:00:02.0: [drm:intel_gmbus_force_bit [i915]] disabling bit-banging on i915 gmbus dpc. force bit now 0 <7> [90.271277] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling always-on <7> [90.271438] [drm:drm_helper_probe_single_connector_modes [drm_kms_helper]] [CONNECTOR:113:HDMI-A-1] disconnected <6> [90.271871] [IGT] kms_cursor_legacy: exiting, ret=77 <7> [90.272156] i915 0000:00:02.0: [drm:i915_drop_caches_set [i915]] Dropping caches: 0x000001dc [0x000001dc]

Created at 2023-03-14 04:19:55