Result:
i915_display_info18 igt_runner18 results18.json results18-xe-load.json guc_logs18.tar i915_display_info_post_exec18 boot18 dmesg18
| Detail | Value |
|---|---|
| Duration | 0.40 seconds |
| Hostname |
shard-lnl-5 |
| Igt-Version |
IGT-Version: 2.3-g77e2babde (x86_64) (Linux: 7.0.0-rc6-lgci-xe-xe-4824-8d31b64e763bc1c7b-debug+ x86_64) |
| Out |
Using IGT_SRANDOM=1774939708 for randomisation Opened device: /dev/dri/card0 Starting subtest: many-large-execqueues-mmap-prefetch Subtest many-large-execqueues-mmap-prefetch: SUCCESS (0.404s) |
| Err |
Starting subtest: many-large-execqueues-mmap-prefetch Subtest many-large-execqueues-mmap-prefetch: SUCCESS (0.404s) |
| Dmesg |
<7> [378.030286] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
<5> [378.030625] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [378.030627] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [378.030628] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [378.030687] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:393:eDP-1] probed modes:
<7> [378.030690] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 60 347710 2880 2928 2960 3040 1800 1803 1809 1906 0x48 0xa
<7> [378.030694] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 120 695310 2880 2928 2960 3040 1800 1803 1809 1906 0x40 0xa
<7> [378.030697] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:402:DP-1]
<7> [378.030701] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:402:DP-1]
<7> [378.030841] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:402:DP-1] disconnected
<7> [378.030845] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:414:DP-2]
<7> [378.030848] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:414:DP-2]
<7> [378.030970] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:414:DP-2] disconnected
<7> [378.030973] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:422:DP-3]
<7> [378.030976] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:422:DP-3]
<7> [378.031095] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:422:DP-3] disconnected
<7> [378.031098] xe 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:393:eDP-1] enabled? yes
<7> [378.031100] xe 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:402:DP-1] enabled? no
<7> [378.031102] xe 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:414:DP-2] enabled? no
<7> [378.031104] xe 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:422:DP-3] enabled? no
<7> [378.031124] xe 0000:00:02.0: [drm:drm_client_firmware_config.isra.0] Not using firmware configuration
<7> [378.031136] xe 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:393:eDP-1] found preferred mode: 2880x1800
<7> [378.031138] xe 0000:00:02.0: [drm:drm_client_modeset_probe] picking CRTCs for 2880x1800 config
<7> [378.031155] xe 0000:00:02.0: [drm:drm_client_modeset_probe] [CRTC:151:pipe A] desired mode 2880x1800 set (0,0)
<7> [378.031782] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [378.031889] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [378.045484] xe 0000:00:02.0: [drm:drm_client_hotplug] fbdev: ret=0
<6> [378.054770] Console: switching to colour dummy device 80x25
<6> [378.055624] [IGT] xe_exec_system_allocator: executing
<7> [378.062955] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [378.063116] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [378.063238] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
<6> [378.064588] [IGT] xe_exec_system_allocator: starting subtest many-large-execqueues-mmap-prefetch
<7> [378.068920] xe 0000:00:02.0: [drm:gsc_work [xe]] Tile0: GT1: GSC proxy init completed
<7> [378.128308] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.137124] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.215699] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.221850] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.298224] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.299704] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.387271] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.390086] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.466983] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<7> [378.468266] xe 0000:00:02.0: [drm:xe_svm_garbage_collector [xe]] Skipping madvise reset for vma.
<6> [378.470525] [IGT] xe_exec_system_allocator: finished subtest many-large-execqueues-mmap-prefetch, SUCCESS
<7> [378.473006] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [378.473943] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [378.491118] xe 0000:00:02.0: [drm:drm_client_dev_restore] fbdev: ret=0
<6> [378.493008] [IGT] xe_exec_system_allocator: exiting, ret=0
<6> [378.508587] Console: switching to colour frame buffer device 180x56
|