Results for igt@kms_properties@invalid-properties-atomic

Result: Pass

i915_display_info23 igt_runner23 results23.json results23-xe-load.json guc_logs23.tar i915_display_info_post_exec23 boot23 dmesg23

DetailValue
Duration 0.14 seconds
Hostname 
shard-lnl-4
Igt-Version 
IGT-Version: 2.3-g15a597610 (x86_64) (Linux: 6.19.0-rc4-lgci-xe-xe-4364-629c8a9146d75c96e+ x86_64)
Out 
Using IGT_SRANDOM=1768145855 for randomisation
Opened device: /dev/dri/card0
Starting subtest: invalid-properties-atomic
Subtest invalid-properties-atomic: SUCCESS (0.141s)
Err 
Starting subtest: invalid-properties-atomic
Subtest invalid-properties-atomic: SUCCESS (0.141s)
Dmesg
<6> [270.125174] Console: switching to colour dummy device 80x25
<6> [270.125462] [IGT] kms_properties: executing
<7> [270.131196] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [270.131206] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [270.131387] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [270.131689] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [270.131694] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [270.131820] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [270.132056] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [270.132059] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [270.132185] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<7> [270.132477] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1]
<7> [270.132481] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:391:eDP-1]
<7> [270.132948] xe 0000:00:02.0: [drm:intel_dp_read_dsc_dpcd [xe]] DSC DPCD: 00 11 00 76 0b 01 01 80 00 01 06 66 08 00 00 00
<7> [270.133260] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] source rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 675000, 810000
<7> [270.133366] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] sink rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [270.133530] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] common rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [270.133727] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Supported Monitor Refresh rate range is 40 Hz - 120 Hz
<5> [270.133732] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [270.133735] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [270.133736] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] DisplayID extension version 0x13, primary use 0x00
<7> [270.133739] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Assigning EDID-1.4 digital sink color depth as 10 bpc.
<5> [270.133741] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [270.133743] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD monitor
<5> [270.133745] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [270.133747] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD size 20, SAD count 0
<5> [270.133749] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [270.133760] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] VRR capable: yes
<7> [270.133933] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [270.134222] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<5> [270.134983] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [270.134985] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [270.134987] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [270.135052] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1] probed modes:
<7> [270.135055] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 60 347710 2880 2928 2960 3040 1800 1803 1809 1906 0x48 0xa
<7> [270.135059] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 120 695310 2880 2928 2960 3040 1800 1803 1809 1906 0x40 0xa
<7> [270.135073] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [270.135076] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [270.135222] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [270.135234] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [270.135237] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [270.135349] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [270.135356] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [270.135358] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [270.135478] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<6> [270.135853] [IGT] kms_properties: starting subtest invalid-properties-atomic
<6> [270.277568] [IGT] kms_properties: finished subtest invalid-properties-atomic, SUCCESS
<7> [270.279055] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [270.279800] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [270.297093] xe 0000:00:02.0: [drm:drm_client_dev_restore] fbdev: ret=0
<6> [270.297606] [IGT] kms_properties: exiting, ret=0
<6> [270.313919] Console: switching to colour frame buffer device 180x56
<7> [270.331397] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [270.331911] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [270.332388] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
<7> [270.332834] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [270.333362] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [270.364489] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [270.365046] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [270.365580] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
Created at 2026-01-11 15:43:51