Result:
i915_display_info5 igt_runner5 results5.json results5-xe-load.json guc_logs5.tar i915_display_info_post_exec5 boot5 dmesg5
| Detail | Value |
|---|---|
| Duration | 0.00 seconds |
| Hostname |
shard-lnl-8 |
| Igt-Version |
IGT-Version: 2.3-gf38f4d8e9 (x86_64) (Linux: 6.19.0-rc1-lgci-xe-xe-4277-11e54b185d83425fa+ x86_64) |
| Out |
Using IGT_SRANDOM=1766241483 for randomisation Opened device: /dev/dri/card0 Starting subtest: atomic No dynamic tests executed. Subtest atomic: SKIP (0.000s) |
| Err |
Starting subtest: atomic Subtest atomic: SKIP (0.000s) |
| Dmesg |
<6> [590.135708] Console: switching to colour dummy device 80x25
<6> [590.135992] [IGT] kms_content_protection: executing
<7> [590.141884] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [590.141893] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [590.142037] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [590.142254] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [590.142256] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [590.142369] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [590.142619] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [590.142623] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [590.142758] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<7> [590.142999] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1]
<7> [590.143002] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:391:eDP-1]
<7> [590.143444] xe 0000:00:02.0: [drm:intel_dp_read_dsc_dpcd [xe]] DSC DPCD: 00 11 00 76 0b 01 01 80 00 01 06 66 08 00 00 00
<7> [590.143756] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] source rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 675000, 810000
<7> [590.143863] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] sink rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [590.143966] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] common rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [590.144090] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Supported Monitor Refresh rate range is 40 Hz - 120 Hz
<5> [590.144094] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [590.144095] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.144096] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] DisplayID extension version 0x13, primary use 0x00
<7> [590.144099] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Assigning EDID-1.4 digital sink color depth as 10 bpc.
<5> [590.144100] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.144102] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD monitor
<5> [590.144104] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.144105] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD size 20, SAD count 0
<5> [590.144107] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.144118] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] VRR capable: yes
<7> [590.144206] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [590.144372] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<5> [590.145145] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [590.145148] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [590.145150] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.145203] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1] probed modes:
<7> [590.145206] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 60 347710 2880 2928 2960 3040 1800 1803 1809 1906 0x48 0xa
<7> [590.145210] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 120 695310 2880 2928 2960 3040 1800 1803 1809 1906 0x40 0xa
<7> [590.145221] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [590.145224] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [590.145350] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [590.145360] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [590.145362] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [590.145477] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [590.145487] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [590.145490] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [590.145613] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<7> [590.163823] xe 0000:00:02.0: [drm:drm_mode_addfb2] [FB:427]
<7> [590.172472] xe 0000:00:02.0: [drm:drm_mode_addfb2] [FB:430]
<6> [590.177444] [IGT] kms_content_protection: starting subtest atomic
<6> [590.177798] [IGT] kms_content_protection: finished subtest atomic, SKIP
<7> [590.179803] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [590.179930] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [590.187115] xe 0000:00:02.0: [drm:drm_client_dev_restore] fbdev: ret=0
<6> [590.187495] [IGT] kms_content_protection: exiting, ret=77
<6> [590.203360] Console: switching to colour frame buffer device 180x56
<7> [590.220585] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [590.220953] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [590.221269] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
<7> [590.221597] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [590.221901] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [590.254580] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [590.255019] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [590.255450] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
|