Result:
i915_display_info5 igt_runner5 results5.json results5-xe-load.json guc_logs5.tar i915_display_info_post_exec5 boot5 dmesg5
| Detail | Value |
|---|---|
| Duration | 0.00 seconds |
| Hostname |
shard-lnl-7 |
| Igt-Version |
IGT-Version: 2.3-gf38f4d8e9 (x86_64) (Linux: 6.19.0-rc1-lgci-xe-xe-4270-84b93f7cc4ceb1c0b+ x86_64) |
| Out |
Using IGT_SRANDOM=1766193474 for randomisation Opened device: /dev/dri/card0 Starting subtest: getfb2-accept-nv12 Subtest getfb2-accept-nv12: SUCCESS (0.001s) |
| Err |
Starting subtest: getfb2-accept-nv12 Subtest getfb2-accept-nv12: SUCCESS (0.001s) |
| Dmesg |
<6> [589.998734] Console: switching to colour dummy device 80x25
<6> [589.998989] [IGT] kms_getfb: executing
<7> [590.004409] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [590.004420] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [590.004567] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [590.004779] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [590.004781] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [590.004893] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [590.005098] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [590.005100] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [590.005249] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<7> [590.005541] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1]
<7> [590.005543] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:391:eDP-1]
<7> [590.005990] xe 0000:00:02.0: [drm:intel_dp_read_dsc_dpcd [xe]] DSC DPCD: 00 11 00 76 0b 01 01 80 00 01 06 66 08 00 00 00
<7> [590.006309] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] source rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 675000, 810000
<7> [590.006418] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] sink rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [590.006520] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] common rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [590.006643] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Supported Monitor Refresh rate range is 40 Hz - 120 Hz
<5> [590.006648] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [590.006650] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.006651] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] DisplayID extension version 0x13, primary use 0x00
<7> [590.006653] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Assigning EDID-1.4 digital sink color depth as 10 bpc.
<5> [590.006655] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.006657] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD monitor
<5> [590.006659] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.006660] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD size 20, SAD count 0
<5> [590.006662] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.006673] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] VRR capable: yes
<7> [590.006778] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [590.006876] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<5> [590.007401] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [590.007404] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [590.007405] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [590.007460] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1] probed modes:
<7> [590.007464] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 60 347710 2880 2928 2960 3040 1800 1803 1809 1906 0x48 0xa
<7> [590.007468] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 120 695310 2880 2928 2960 3040 1800 1803 1809 1906 0x40 0xa
<7> [590.007481] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [590.007484] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [590.007625] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [590.007635] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [590.007638] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [590.007751] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [590.007758] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [590.007760] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [590.007862] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<7> [590.024721] xe 0000:00:02.0: [drm:drm_mode_addfb2] [FB:429]
<7> [590.025029] xe 0000:00:02.0: [drm:drm_mode_addfb2] [FB:429]
<7> [590.025188] xe 0000:00:02.0: [drm:drm_mode_addfb2] [FB:429]
<6> [590.025458] [IGT] kms_getfb: starting subtest getfb2-accept-nv12
<7> [590.027034] xe 0000:00:02.0: [drm:drm_mode_addfb2] [FB:430]
<6> [590.027324] [IGT] kms_getfb: finished subtest getfb2-accept-nv12, SUCCESS
<7> [590.027942] xe 0000:00:02.0: [drm:drm_mode_addfb2] [FB:429]
<7> [590.028727] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [590.028855] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [590.035469] xe 0000:00:02.0: [drm:drm_client_dev_restore] fbdev: ret=0
<6> [590.035846] [IGT] kms_getfb: exiting, ret=0
<6> [590.052330] Console: switching to colour frame buffer device 180x56
<7> [590.069214] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [590.069709] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [590.070102] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
<7> [590.070566] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [590.071016] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [590.103334] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [590.103875] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [590.104400] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
|