Result:
i915_display_info19 igt_runner19 results19.json results19-xe-load.json guc_logs19.tar boot19 dmesg19
| Detail | Value |
|---|---|
| Duration | 0.15 seconds |
| Hostname |
shard-lnl-3 |
| Igt-Version |
IGT-Version: 2.3-g726612327 (x86_64) (Linux: 6.19.0-rc5-lgci-xe-xe-4368-e9383891a008f23b4+ x86_64) |
| Out |
Using IGT_SRANDOM=1768252470 for randomisation Opened device: /dev/dri/card0 Starting subtest: invalid-properties-atomic Subtest invalid-properties-atomic: SUCCESS (0.146s) |
| Err |
Starting subtest: invalid-properties-atomic Subtest invalid-properties-atomic: SUCCESS (0.146s) |
| Dmesg |
<6> [256.128451] Console: switching to colour dummy device 80x25
<6> [256.128776] [IGT] kms_properties: executing
<7> [256.134235] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [256.134245] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [256.134417] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [256.134709] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [256.134713] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [256.134852] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [256.135107] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [256.135111] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [256.135239] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<7> [256.135569] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1]
<7> [256.135573] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:391:eDP-1]
<7> [256.136039] xe 0000:00:02.0: [drm:intel_dp_read_dsc_dpcd [xe]] DSC DPCD: 00 11 00 76 0b 01 01 80 00 01 06 66 08 00 00 00
<7> [256.136366] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] source rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 675000, 810000
<7> [256.136649] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] sink rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [256.136903] xe 0000:00:02.0: [drm:intel_dp_print_rates [xe]] common rates: 162000, 216000, 243000, 270000, 324000, 432000, 540000, 810000
<7> [256.137250] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Supported Monitor Refresh rate range is 40 Hz - 120 Hz
<5> [256.137259] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [256.137262] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [256.137264] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] DisplayID extension version 0x13, primary use 0x00
<7> [256.137266] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] Assigning EDID-1.4 digital sink color depth as 10 bpc.
<5> [256.137269] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [256.137271] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD monitor
<5> [256.137274] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [256.137276] xe 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:391:eDP-1] ELD size 20, SAD count 0
<5> [256.137279] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [256.137292] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] VRR capable: yes
<7> [256.137396] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] DFP max bpc 0, max dotclock 0, TMDS clock 0-0, PCON Max FRL BW 0Gbps
<7> [256.137513] xe 0000:00:02.0: [drm:intel_dp_set_edid [xe]] [CONNECTOR:391:eDP-1] RGB->YcbCr conversion? no, YCbCr 4:2:0 allowed? yes, YCbCr 4:4:4->4:2:0 conversion? no
<5> [256.138042] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [256.138044] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<5> [256.138045] [drm] DisplayID checksum invalid, remainder is 248 (ignoring)
<7> [256.138102] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:391:eDP-1] probed modes:
<7> [256.138107] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 60 347710 2880 2928 2960 3040 1800 1803 1809 1906 0x48 0xa
<7> [256.138111] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] Probed mode: "2880x1800": 120 695310 2880 2928 2960 3040 1800 1803 1809 1906 0x40 0xa
<7> [256.138123] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1]
<7> [256.138127] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:400:DP-1]
<7> [256.138254] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:400:DP-1] disconnected
<7> [256.138265] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2]
<7> [256.138269] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:412:DP-2]
<7> [256.138426] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:412:DP-2] disconnected
<7> [256.138456] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3]
<7> [256.138462] xe 0000:00:02.0: [drm:intel_dp_detect [xe]] [CONNECTOR:420:DP-3]
<7> [256.138678] xe 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:420:DP-3] disconnected
<6> [256.139214] [IGT] kms_properties: starting subtest invalid-properties-atomic
<6> [256.285464] [IGT] kms_properties: finished subtest invalid-properties-atomic, SUCCESS
<7> [256.286286] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [256.286429] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [256.303807] xe 0000:00:02.0: [drm:drm_client_dev_restore] fbdev: ret=0
<6> [256.304196] [IGT] kms_properties: exiting, ret=0
<6> [256.320452] Console: switching to colour frame buffer device 180x56
<7> [256.337838] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [256.338197] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [256.338500] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
<7> [256.338853] xe 0000:00:02.0: [drm:intel_power_well_enable [xe]] enabling DC_off
<7> [256.339236] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 02 to 00
<7> [256.370862] xe 0000:00:02.0: [drm:intel_power_well_disable [xe]] disabling DC_off
<7> [256.371289] xe 0000:00:02.0: [drm:skl_enable_dc6 [xe]] Enabling DC6
<7> [256.371655] xe 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [xe]] Setting DC state from 00 to 02
|