Oops#1 Part21
<7>[   58.822548] i915 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:617:DP-3] enabled? no
<7>[   58.822552] i915 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:626:DP-4] enabled? no
<7>[   58.822686] i915 0000:00:02.0: [drm:drm_client_firmware_config.isra.0] Not using firmware configuration
<7>[   58.822708] i915 0000:00:02.0: [drm:drm_client_modeset_probe] [CONNECTOR:588:HDMI-A-1] found preferred mode: 1920x1080
<7>[   58.822711] i915 0000:00:02.0: [drm:drm_client_modeset_probe] picking CRTCs for 1920x1080 config
<7>[   58.822737] i915 0000:00:02.0: [drm:drm_client_modeset_probe] [CRTC:171:pipe A] desired mode 1920x1080 set (0,0)
<7>[   58.825154] i915 0000:00:02.0: [drm:drm_client_hotplug] fbdev: ret=0
<7>[   58.825170] i915 0000:00:02.0: [drm:drm_sysfs_hotplug_event] generating hotplug event
<7>[   58.834600] i915 0000:00:02.0: [drm:intel_power_well_disable [i915]] disabling DC_off
<7>[   58.834873] i915 0000:00:02.0: [drm:skl_enable_dc6 [i915]] Enabling DC6
<7>[   58.835057] i915 0000:00:02.0: [drm:gen9_set_dc_state.part.0 [i915]] Setting DC state from 00 to 02
<7>[   58.843971] i915 0000:00:02.0: [drm:drm_fb_helper_hotplug_event] 
<7>[   58.843983] i915 0000:00:02.0: [drm:drm_client_modeset_probe] 
<7>[   58.844096] i915 0000:00:02.0: [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:588:HDMI-A-1]
<7>[   58.844112] i915 0000:00:02.0: [drm:intel_hdmi_detect [i915]] [CONNECTOR:588:HDMI-A-1]
<6>[   58.856478] snd_hda_intel 0000:00:1f.3: codec_mask forced to 0x4
<7>[   58.871385] i915 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:588:HDMI-A-1] Supported Monitor Refresh rate range is 0 Hz - 0 Hz
Oops#1 Part20
<7>[   58.871402] i915 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:588:HDMI-A-1] Assigning EDID-1.4 digital sink color depth as 8 bpc.
<7>[   58.871407] i915 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:588:HDMI-A-1] ELD monitor fitHeadless4k
<7>[   58.871411] i915 0000:00:02.0: [drm:update_display_info.part.0] [CONNECTOR:588:HDMI-A-1] ELD size 36, SAD count 0
<7>[   58.871843] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpb] NAK for addr: 0040 w(1)
<7>[   58.872067] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpb] NAK on first message, retry
<7>[   58.872657] i915 0000:00:02.0: [drm:do_gmbus_xfer [i915]] GMBUS [i915 gmbus dpb] NAK for addr: 0040 w(1)
<7>[   58.872882] i915 0000:00:02.0: [drm:drm_dp_dual_mode_detect [drm_display_helper]] DP dual mode HDMI ID:  (err -6)
<7>[   58.873307] i915 0000:00:02.0: [drm:drm_mode_prune_invalid] Rejected mode: "3840x2160": 15 128430 3840 3889 3921 4000 2160 2163 2169 2195 0x40 0xa (VIRTUAL_X)
<7>[   58.873317] i915 0000:00:02.0: [drm:drm_mode_prune_invalid] Rejected mode: "2880x1800": 11 60000 2880 2888 2984 3040 1800 1802 1820 1845 0x40 0xa (VIRTUAL_X)
<7>[   58.873324] i915 0000:00:02.0: [drm:drm_mode_prune_invalid] Rejected mode: "2560x1600": 13 60000 2560 2568 2664 2720 1600 1602 1620 1645 0x40 0xa (VIRTUAL_X)
<7>[   58.873330] i915 0000:00:02.0: [drm:drm_mode_prune_invalid] Rejected mode: "2560x1440": 15 60000 2560 2568 2664 2720 1440 1442 1460 1485 0x40 0xa (VIRTUAL_X)
<7>[   58.873336] i915 0000:00:02.0: [drm:drm_mode_prune_invalid] Rejected mode: "2048x1536": 17 60000 2048 2056 2152 2208 1536 1538 1556 1581 0x40 0xa (VIRTUAL_X)