Oops#2 Part19
<7>[  645.075619] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.crtc_vblank_start (expected 1801, found 0)
<7>[  645.075757] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.crtc_vsync_start (expected 1803, found 0)
<7>[  645.075888] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.crtc_vsync_end (expected 1809, found 0)
<7>[  645.076015] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.crtc_vtotal (expected 1878, found 0)
<7>[  645.076140] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.crtc_vblank_end (expected 1878, found 0)
<7>[  645.076267] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in pixel_multiplier (expected 1, found 0)
<7>[  645.076395] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.flags (2) (expected 2, found 0)
<7>[  645.076535] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.flags (8) (expected 8, found 0)
<7>[  645.076670] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in enhanced_framing (expected yes, found no)
Oops#2 Part18
<7>[  645.076797] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in pipe_bpp (expected 30, found 0)
<7>[  645.076923] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.pipe_mode.crtc_clock (expected 513820, found 0)
<7>[  645.077049] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in hw.adjusted_mode.crtc_clock (expected 513820, found 0)
<7>[  645.077175] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in port_clock (expected 540000, found 0)
<7>[  645.077303] i915 0000:00:02.0: [drm:intel_pipe_config_compare [i915]] [CRTC:151:pipe A] fastset requirement not met in set_context_latency (expected 1, found 0)
<7>[  645.077430] i915 0000:00:02.0: [drm:intel_atomic_check [i915]] [CRTC:151:pipe A] fastset requirement not met, forcing full modeset
<7>[  645.077572] i915 0000:00:02.0: [drm:intel_dpll_crtc_put [i915]] [CRTC:151:pipe A] releasing DPLL 0
<7>[  645.077747] i915 0000:00:02.0: [drm:skl_compute_wm [i915]] Enabled dbuf slices 0xf -> 0x1 (total dbuf slices 0xf), mbus joined? yes->no
<7>[  645.077876] i915 0000:00:02.0: [drm:skl_compute_wm [i915]] [CRTC:151:pipe A] dbuf slices 0xf -> 0x0, ddb (0 - 4096) -> (0 - 0), active pipes 0x1 -> 0x0
<7>[  645.078033] i915 0000:00:02.0: [drm:skl_print_plane_ddb_changes [i915]] [PLANE:145:cursor A]   ddb (4001 - 4096) -> (   0 -    0), size   95 ->    0
<7>[  645.078162] i915 0000:00:02.0: [drm:intel_cdclk_atomic_check [i915]] [CRTC:151:pipe A] min cdclk: 256910 kHz -> 0 kHz
Oops#2 Part17
<7>[  645.078300] i915 0000:00:02.0: [drm:intel_cdclk_atomic_check [i915]] Can change cdclk via squashing
<7>[  645.078433] i915 0000:00:02.0: [drm:intel_cdclk_atomic_check [i915]] New cdclk calculated to be logical 172800 kHz, actual 172800 kHz
<7>[  645.078585] i915 0000:00:02.0: [drm:intel_cdclk_atomic_check [i915]] New voltage level calculated to be logical 0, actual 0
<7>[  645.078749] i915 0000:00:02.0: [drm:intel_crtc_state_dump [i915]] [CRTC:151:pipe A] enable: no [modeset]
<7>[  645.078881] i915 0000:00:02.0: [drm:intel_crtc_state_dump [i915]] [PLANE:35:plane 1A] fb: [NOFB], visible: no
<7>[  645.079011] i915 0000:00:02.0: [drm:intel_crtc_state_dump [i915]] [PLANE:65:plane 2A] fb: [NOFB], visible: no
<7>[  645.079137] i915 0000:00:02.0: [drm:intel_crtc_state_dump [i915]] [PLANE:95:plane 3A] fb: [NOFB], visible: no
<7>[  645.079264] i915 0000:00:02.0: [drm:intel_crtc_state_dump [i915]] [PLANE:125:plane 4A] fb: [NOFB], visible: no
<7>[  645.079392] i915 0000:00:02.0: [drm:intel_crtc_state_dump [i915]] [PLANE:135:plane 5A] fb: [NOFB], visible: no
<7>[  645.079539] i915 0000:00:02.0: [drm:intel_crtc_state_dump [i915]] [PLANE:145:cursor A] fb: [NOFB], visible: no
<7>[  645.080140] i915 0000:00:02.0: [drm:intel_edp_backlight_off [i915]] 
<7>[  645.283939] i915 0000:00:02.0: [drm:intel_backlight_set_pwm_level [i915]] [CONNECTOR:508:eDP-1] set backlight PWM = 0
<7>[  645.285673] i915 0000:00:02.0: [drm:intel_disable_transcoder [i915]] disabling pipe A
<7>[  645.292891] i915 0000:00:02.0: [drm:icp_irq_handler [i915]] hotplug event received, stat 0x00010000, dig 0x00000089, pins 0x00000010, long 0x00000000
Oops#2 Part16
<7>[  645.293476] i915 0000:00:02.0: [drm:intel_hpd_irq_handler [i915]] digital hpd on [ENCODER:507:DDI A/PHY A] - short
<7>[  645.294924] i915 0000:00:02.0: [drm:intel_dp_hpd_pulse [i915]] got hpd irq on [ENCODER:507:DDI A/PHY A] - short
<7>[  645.295055] i915 0000:00:02.0: [drm:intel_pps_off_unlocked [i915]] [ENCODER:507:DDI A/PHY A] PPS 0 turn panel power off
<7>[  645.295628] i915 0000:00:02.0: [drm:intel_pps_off_unlocked [i915]] [ENCODER:507:DDI A/PHY A] PPS 0 wait for panel power off time
<7>[  645.296155] i915 0000:00:02.0: [drm:wait_panel_status [i915]] [ENCODER:507:DDI A/PHY A] PPS 0 mask: 0xb0000000 value: 0x00000000 PP_STATUS: 0xa0000002 PP_CONTROL: 0x00000060
<7>[  645.348364] i915 0000:00:02.0: [drm:icp_irq_handler [i915]] hotplug event received, stat 0x00010000, dig 0x0000008a, pins 0x00000010, long 0x00000010
<7>[  645.348993] i915 0000:00:02.0: [drm:intel_hpd_irq_handler [i915]] digital hpd on [ENCODER:507:DDI A/PHY A] - long
<7>[  645.349431] i915 0000:00:02.0: [drm:wait_panel_status [i915]] Wait complete
<7>[  645.349522] i915 0000:00:02.0: [drm:intel_hpd_irq_handler [i915]] Received HPD interrupt on PIN 4 - cnt: 10
<7>[  645.352077] i915 0000:00:02.0: [drm:intel_dpll_disable [i915]] disable DPLL 0 (active 0x1, on? 1) for [CRTC:151:pipe A]
<7>[  645.352682] i915 0000:00:02.0: [drm:intel_pps_vdd_on_unlocked [i915]] [ENCODER:507:DDI A/PHY A] PPS 0 turning VDD on
<7>[  645.353178] i915 0000:00:02.0: [drm:wait_panel_power_cycle [i915]] [ENCODER:507:DDI A/PHY A] PPS 0 wait for panel power cycle (497 ms remaining)